Boring on the Mill - 4: Rough Cut
therefore have been pre-drilled . Once the work piece is pre drilled within a sixteenth of an inch from its finished size, use the offset boring head to enlarge the hole to a rough size. |
|||||||||||||
|
Boring on the Mill - 4: Rough Cut
|
|||||||||||||
| WARNING: Machine tools present a safety hazard. Improper operation can result in severe injury. These topics are for non-laboratory study only and are not to be used in conjunction with the operation of any tool or machine described herein. Never use a machine tool without the supervision of a qualified instructor. | |||||||||||||
|
|||||||||||||
| It is important to note that the offset boring head is used to finish a hole to size. The hole must therefore have been pre-drilled . Once the work piece is pre drilled within a sixteenth of an inch from its finished size, use the offset boring head to enlarge the hole to a rough size. |
|||||||||||||